Cellular-connected systems can use email or SMS. Ethernet-connected systems may only use email, but can send email to
cellular phones as a SMS message depending upon the network carrier. To send email to a Verizon phone, use the phone
number followed by @vtext.com, for example, 1234567890@vtext.com.
Following these instructions using the
DXM Configuration Tool to program the controller for email and/or SMS.
1. Set the time on the DXM Controller.
2. Define the Network Interface settings by selecting either Ethernet or Cell on the Cloud Services screen.
3. If you selected Ethernet, configure your Ethernet connection by setting the IP settings on the Network screen.
4. Set the email and message parameters on the Mail and Messaging screen.
5. To send alert messages, define the threshold rule to use email and/or SMS.
6. To send log files, define the log file parameters.
5.10 Define the Network Interface Settings
On the Cloud Services screen, define the network connection settings by selecting Ethernet or Cell from the Network
Interface drop-down list. This determines how the DXM Controller sends data. When selecting Ethernet, provide the
network parameters on the Network screen. If you don't require pushing data to a web server, set the Cloud Push
interval to zero.
5.10 Configuring your Ethernet Connection
To send email based on a threshold rule or to email log files, first define the network and email servers. In the
DXM
Configuration Tool, go to Settings > Network.
1. To define the Ethernet IP address, give the DXM device a static IP address. In most cases you may select the
device to use DHCP and have the IP address automatically assigned.
2. DNS settings are not typically required. The DXM device uses a public service to resolve Domain names, but if the
network connection does not have Internet access, the DNS settings may be required.
DXM100 Controller Instruction Manual
36 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
