55R5900103 /02 C-10, C-5
Image 4–21
Gives an overview of the current configuration.
Click Finish configuration. When your device is connected to the internet and firmware update was set to
automatic, a software check and an update will be executed. The Configurator starts automatically with a
message that your device is configured.
Image 4–22
4.14 Start up without configuration
How to start
1. Plug in a Button and start sharing your screen.
As soon as a user connects to the Base Unit, the default wallpaper will be shown on the meeting room
display and the unit can be used with it's default configuration. However, as long as the Configuration
Wizard has not been completed, the initial startup screen will again be shown at each reboot of the device.
Registration of the device is only possible in the Configuration Wizard or from the ClickShare Configurator
and when the Base Unit is connected to the internet.
C-10, C-5 Installation
To Next Page
Loading...
