R5900103 /00 C-10, C-544
4.10 Power connection
About power
An external power adapter is delivered with the product. The output rate is 12 VDC 2A.
CAUTION: Once the Base Unit is powered, it starts up. Then the power button can be used to
switch on or off.
How to connect the external power adapter
1. Plug the barrel connector of the power adapter into the power input of the Base Unit.
2. Slide a power input adaptor piece (US, AU, IN, CH, EU or UK) on the power adapter of the ClickShare until
it clicks. Use the one
which is applicable in your country.
Image 4–11 Power adapter
3. Connect the power cable to the wall outlet.
4.11 Starting up for the first time
How to startup
The following steps are necessary before the Base Unit can be used:
1. Connect the screen and the power to the Base Unit.
2. Base Unit needs Internet access to start up for the first time. The Base Unit updates to the latest firmware
version.
3. Register and configure your device in XMS cloud.
4. Pair the (optional) Button with the Base Unit.
5. Base Unit is ready to use.
C-10, C-5 Installation
To Next Page
Loading...
Need help?
General
