97R5900103 /00 C-10, C-5
All Buttons used with the Base Unit are indicated in the Buttons List. The list contains the serial number, MAC
address, article code and the firmware version, the number of connections and last connection date and time.
It is possible to update the software of the Buttons over Wi-Fi.
The Buttons can be connected to Base Unit or to an external access point.
To edit the settings
1. Log in to the Configurator.
2. Click System → Buttons.
Image 6–38 Buttons overview
The current state is indicated and the list of Buttons is given.
3. Click Edit settings.
4. Select to which access point the Buttons are connected. Click on the drop down list next to Buttons
connect to and select the desired point.
Depending on the selection, your ClickShare device or external access point, settings should be filed out.
For your ClickShare device, no settings are needed.
6.27 Buttons, External access point, mode EAP-
TLS
How to fill out
1. Fill out a Corporate SSID.
C-10, C-5 Configurator
To Next Page
Loading...
