11CLM W6
1. Safety
On servicing
Do not attempt to service this product yourself, as opening or removing covers
may expose you to dangerous voltage potentials and risk of electric shock.
Refer all servicing to qualied service personnel.
Fence off a restricted area of at least 3 meters around the projector using an
eye-catching fence and “KEEP OUT” signs. This to prevent unauthorized per-
sons coming near the projector during servicing.
Unplug this product from the wall outlet and refer servicing to qualied service
technicians under the following conditions:
When the power cord or plug is damaged or frayed.
If liquid has been spilled into the equipment.
If the product has been exposed to rain or water.
If the product does not operate normally when the operating instructions are
followed. Adjust only those controls that are covered by the operating instruc-
tions since improper adjustment of the other controls may result in damage
and will often require extensive work by a qualied technician to restore the
product to normal operation.
If the product has been dropped or the cabinet has been damaged.
If the product exhibits a distinct change in performance, indicating a need for
service.
Replacement parts: When replacement parts are required, be sure the service
technician has used original Barco replacement parts or authorized replacement
parts which have the same characteristics as the Barco original part. Unauthor-
ized substitutions may result in degraded performance and reliability, re, elec-
tric shock or other hazards. Unauthorized substitutions may void warranty.
Safety check: Upon completion of any service or repairs to this projector, ask the
service technician to perform safety checks to determine that the product is in
proper operating condition.
-
-
-
-
-
-
To Next Page
Loading...
Need help?
General
