51CLM W6
5. Appendices
The projector automatically detects the lamp life. When the lamp life is nearing
the end of use, you will receive a warning message. When you see this message,
please contact your local reseller or service center to change the lamp as soon as
possible. Make sure the projector has been cooled down for at least 30 minutes
before changing the lamp.
Turn the projector off and unplug the power cord.
Allow the projector to cool down for at least 30 minutes.
Unscrew the two screws on the lamp door. 1
Slide the lamp door toward the bottom of the projector.
Unscrew the four screws on the lamp cover. 2
Lift up the lamp handle and remove the lamp module slowly and carefully. 3
To replace the lamp module, reverse the previous steps.
Turn on the projector and use “Lamp Hour Reset” after the lamp module is
replaced.
1.
2.
3.
4.
5.
6.
7.
8.
5.4 Replacing the Lamp
Procedure:
1
2 3
To Next Page
Loading...
Need help?
General
