42 CLM W6
4. User Controls
Eco Network Power
Switch on/off the network power to save power.
Off: Default value. Network is enable in standby.
On: Network is not available in standby.
RS232 Baudrate
Select RS232 baudrate.
115200: Default value for this function.
9600/19200: Other options.
Network
View the relevant network information.
IP Address: Default value is 192.168.0.100.
Subnet Mask: Default value is 255.255.255.0.
Gateway
DHCP: Default value is Off, key in the IP address manually and press
APPLY.
Apply:
The DHCP function must be set to “On” and press “Apply” to get the
IP address from DHCP server automatically.
It takes several seconds to get the IP.
In case of fail to get the IP address, please re-apply again.
Menu Position
Shift the menu box to a position.
Center: Default value for this function.
Top left
Top right
Bottom Left
Bottom right
Start Up Logo
Display the logo in the start up screen.
On: Logo will be displayed at start up of the projector.
Off: Display a blank image.
-
-
-
To Next Page
Loading...
Need help?
General
