Barco MXRT-1450 - Installation Options; After Installation

3. Driver and software installation
This can be done from the command shell, from the Run command, or from a command shortcut. The
setup program will automatically install the drivers for any MXRT boards that are present, the BarcoMed
Self Exam program, and QAWeb (if part of the installation package).
Configure silent installation options
You can modify the setup.ini file at the Barco root folder to customize certain silent install behavior. The
configurable options are listed in the [Custom] section of the setup.ini file.
Reboot
• Locate the [Custom] section of setup.ini.
• If set to Yes (default), the installer will prompt the user or launch a timer to reboot following software
installation. If No, the prompt/timer is not shown.
3.4 Installation options
Configure installation options
You can modify the setup.ini file at the Barco root folder to change the default setting of MXRT driver after
either installation or silent installation.
Install driver in 24-bit
• Locate the [M XRT_WDDM] section of setup.ini
• Remove -30bit command line parameter from both Install and SilentInstall lines
• Modify the default.ini file, found in:
Barco_MXRT_Driver_SoftwarePackage_xxxx\Setup_Barco_Productiv-
ity_Tools.x.x.x\
Change Color%20Depth\30BitDesktop to false.
Install driver with Coronis Fusion displays in DualView mode
• Locate the [M XRT_WDDM] section of setup.ini
• Remove -singleview command line parameter from both Install and SilentInstall lines
Install driver with VirtualView enabled
• Locate the [M XRT_WDDM] section of setup.ini
•Add-virtualview parameter to both Install and SilentInstall lines
• Modify the default.ini file, found in:
Barco_MXRT_Driver_SoftwarePackage_xxxx\Setup_Barco_Productiv-
ity_Tools.x.x.x\
Change VirtualView\FeatureEnabled to true.
3.5 After installation
Installation verification
To verify that the driver was installed, go to the Windows Control Panel,selectSystem, select Device
Manager, then select Displa y Adapters. Verify that Barco Display Controllers are properly identified, as
shown below:
K5905271 DISPLAY CONTROLLER 27/02/2017
15