Barco MXRT-1450 - Operation; Configuration; I-Luminate; Description

5. Driver and software features
Default behavior
FindCursor is enabled by default.
5.6.2 O peration
Using FindCursor
To quickly locate the cursor, hold down the hotkey (default: Control+Shift+F). The cursor location will be
highlighted by a circle, which appears yellow on color displays and gray on grayscale displays.
5.6.3 Configuration
Configuring FindCursor
• Enable/Disable: Use the checkbox to enable or disable FindCursor.
• Hotkey: The currently selected hotkey is displayed in the edit box. To program a new hotkey, highlight
the edit box, and input the new keystrokes. The change will take affect right away.
5.7 I-Luminate
5.7.1 Description
Overview
This feature boosts the luminance of supported displays.
Image 5-8
Supported display controllers
When driven by an MXRT-x400 or later display controller, I-Luminate can be enabled on supported dis-
plays, including MDMC-12133, MDMG-5221, and MDCG-5221.
5.7.2 O peration
Using I-Luminate
A hotkey will boost the luminance on all selected displays.
5.7.3 Configuration
Configuring I-Luminate
• Enable I-Luminate for these displays: All displays that support I-Luminate arelistedintheconfigu-
ration section. Click on the checkbox to enable the feature on that display.
• Hotkey to enabled I-Luminate: Click Clear to remove a hotkey. Click on the hotkey box to enter a
new one.
• Timeout: The slider bar sets the time-out period for the I-Luminate mode.
K5905271 DISPLAY CONTROLLER 27/02/2017
27