Barco MXRT-1450 - Configuration; Singleview; Description; Operation

5. Driver and software features
5.9.3 Configuration
Configuring Reading Environment
• Hotkey: Click Clear to remove a hotkey. Click on the hotkey box to enter a new one.
• Copy captured image to Windows clipboard: Check this box to copy the image of the display with
the cursor to the clipboard.
• Output directory: To save the capture images as files, enter a target location here.
• File format: Use these radio buttons to choose the file format as either PNG or PPM.
5.10 SingleView
5.10.1 Description
Overview
SingleView enables the use of a Coronis Fusion display as a single display in the Windows desktop and
eliminates any tearing down the center . SingleView is enabled by default on Coronis Fusion displays.
Image 5-11
Supported displays
When driven by an MXRT-x400 or later display controller, SingleView is supported on all Coronis Fusion
displays.
5.10.2 O peration
Using SingleView
A button will switch all Coronis Fusion displays into SingleView, and another will switch all into DualView.
Hotkeys are available for both actions.
When in SingleView, it is possible to have the left and right halves out of position, and a button will swap
the two.
5.10.3 Configuration
Configuring SingleView
• Activate SingleView mode now: Changes all Coronis Fusion displays into SingleView mode.
• Swap Left/Right: This can correct misaligned SingleView displays one at a time.
• Activate DualView mode now: Changes all Coronis Fusion displays into SingleView mode.
• Hotkeys: SingleView and DualView activations have individual hotkeys. Click Clear to remove a
hotkey. Click on the hotkey box to enter a new one.
30
K5905271 DISPLAY CONTROLLER 27/02/2017