Display installation
32 System manual Nio 5MP
Figure 10
To change from landscape to portrait, turn clockwise.
Notice:
Before installing the Nio driver, put the display panel in
portrait orientation. Then install the driver and reboot
the PC.
From that moment on, the Nio system will adapt the
image orientation to the display panel orientation at each
reboot.
So, if you change the panel orientation after the initial
installation, you have to reboot the PC to adapt the
image orientation to the panel orientation.
Power connection
To connect the power:
1. To get access to the connectors, remove the
connector compartment cover by pulling down the 2
clips at the top of the cover.
2. Connect the output of the 12V DC power supply to
the DC input of the display.
BARCO
To Next Page
Loading...
