Software installation
System manual Nio 5MP 47
(such as OpenGL).
If you are unsure whether or not your application
requires DirectDraw to be enabled, contact your
application provider.
Installing the Nio Windows software
Using the BarcoMed Product Installation Wizard
To install your Nio Windows Display Controller Driver and
the NioWatch software for the first time follow the steps
below.
If you are reinstalling the drivers or installing a new
driver release over an existing driver release skip to the
step 5:
1. Boot your system, and log in using an account with
administrator privileges.
2. For each BarcoMed Nio display controller installed in
your system Windows will launch the “Found New
Hardware Wizard”. Click “Cancel”. Continue to click
“Cancel” until Windows stops launching the “Found
New Hardware Wizard”. Please be patient as this may
take several minutes while Windows scans its library
of Plug-and-Play device drivers to see if it has a
driver for your BarcoMed Nio controller.
3. If Windows advises you that it has finished installing
all the new devices in your system and that you must
reboot your system in order for the changes to take
effect, click “No”.
4. Insert your Nio Software CD into your computer’s CD
drive. If the “BarcoMed Product Installation
Wizard” doesn’t start within 3 minutes, browse the
contents of your Nio Software CD and double click on
the file: “Setup.exe” to start the wizard.
To Next Page
Loading...
