Display installation
34 System manual Nio 5MP
Figure 13
Video connection
Connecting DVI signals: One display:
1. Connect one end of the DVI cable to the DVI input of
the display.
2. Connect the other end of the DVI cable to the DVI
connector of the display controller board. If this
board has 2 video heads (2 video outputs), connect
to Vid 1 (Head A).
Connecting DVI signals: Two displays:
1. Connect the left display (when looking at the front
side) to Vid 1 as described above.
2. Connect the second display to Vid 2 (Head B).
To Next Page
Loading...
