Barco NIO 5MP - Attaching the Display to an Arm

Attaching the display to an arm
38 System manual Nio 5MP
Attaching the display to an arm
The panel, standard attached to the tilt & swivel foot, is
compatible with the VESA 100 mm standard. So it can be
used with an arm stand according to the VESA 100 mm
standard.
Therefore, the tilt & swivel foot must be removed from
the panel.
Important:
• Use an arm that is approved by VESA (according to
the VESA 100 mm standard).
• Use an arm that can support a weight of at least 13
kg (28.66 lbs).
To attach the display to an arm stand:
1. Put the display face down on a clean surface. Be
careful not to damage the panel screen.
2. Remove the tilt & swivel foot cover.
3. Remove the small screw (A) fixing the small plastic
cover on top of the foot. Next, remove the small
cover itself.