Display Controller hardware tab
60 System manual Nio 5MP
Using The BarcoMed Hardware Tab
To access the BarcoMed Hardware Tab do the following:
1. Open the “Display Properties Control Panel” by right
clicking on the desktop, then select “Properties”.
2. Click on the “Settings” tab. Double click on the
rectangle that represents one of the heads of the the
BarcoMed Display Controller you are working with to
bring up its properties page. Click on the “BarcoMed
Hardware Tab” (see figure 34 on page 61).
2MP1NT
PCI Information
Only
2MP2
PCI Information
Only
4MP2
PCI Information
Only
5MP1H
PCI Information
Only
5MP2
PCI Information
Only
Table 1:
AURA
Controllers
Non-AURA
Controllers
BarcoMed
Hardware Tab
Support
To Next Page
Loading...
