Display Controller hardware tab
System manual Nio 5MP 63
display adapters installed in the system and will be
named BarcoMedDeviceInfo.txt. This report will be saved
on the desktop. These files can be emailed to our
customer support department when reporting a problem.
To locate the closest BarcoView Support office, see the
Support section on www.barcomedical.com. If your
system is connected to the internet and a web browser is
installed you can click on the link at the top of the
BarcoMed Hardware Tab to get to our web site.
“Update Device...” Button: Clicking this button will run
the BarcoMed Hardware Configuration Wizard. This
program allows the user to flash update the firmware
stored in the ROM of the currently selected BarcoMed
Display Controller. The BarcoMed Hardware
Configuration Wizard is a “wizard style” application that
uses dialog boxes to guide the user through the flash
update procedure. The user will be prompted to select a
firmware update file to use for the update therefore you
will need a firmware update file for your specific
BarcoMed Display Controller in order to update it’s
firmware. This file will be provided by BarcoView MIS if
and when a firmware update is required.
Special Note: The BarcoMed Hardware Configuration
Wizard is applicable only for AURA-based Display
Controller(s).
To Next Page
Loading...
