Troubleshooting
86 System manual Nio 5MP
rate that your Nio display supports from the dialog
box and click “OK”.
Tip: In the Adapter box, the Adapter string shows if
this display is the First View or the Second View
attached to the Display Controller. Please make a
note of this, so that you can arrange the displays in
the correct order later if necessary.
6. Click “OK” on the bottom of the Adapter Control
Panel. If the “OK” button on the bottom of the
Adapter Control Panel is not visible, press the “TAB”
key once and then press “CTRL”+“Enter” to select
“OK”.
7. Click “OK” in the “Windows will now apply your new
desktop settings” dialog box. Your Nio display should
now synchronize and display the Windows desktop.
8. Click “Yes” when asked, “Your desktop has been
reconfigured. Do you want to keep these settings?”
To set the resolution of the second display attached to
the BarcoMed Display Controller you are working with,
go back to the “Settings” tab of the “Display Properties
Control Panel”. Attach the display you detached in step 2
above, by right clicking on the rectangle that repre-
sents it and selecting “Attached”.
Now repeat steps 5 - 8 above for this display.
If you are using a Quad-Head Configuration repeat all of
the above steps for the two displays on the second
display controller.
Tip: After installing DualView and setting the resolutions
in a Quad-Head Configuration you may need to drag the
heads into the proper position in the window on the
“Settings” tab, so that the arrangement in the window on
To Next Page
Loading...
