Troubleshooting
88 System manual Nio 5MP
BarcoMed Product Installation Wizard” with the
following changes.
1. Boot your system, and log in using an account with
administrator privileges.
2. Insert your Nio Software CD into your computer’s CD
drive. If the “BarcoMed Product Installation
Wizard” doesn’t start within 3 minutes, browse the
contents of your Nio Software CD and double click on
the file: “Setup.exe” to start the wizard.
The wizard will begin by displaying the screen shown
in figure 40 below.
Figure 40
3. To update the driver, clear the checkbox next to
“NioWatch Setup” and click “Install”.
4. Please turn to Step 6 on page 50 and following the
instructions in the section titled “Driver
To Next Page
Loading...
