Why are the colors of my Barco Projector image out of place?
If the colors of the projected image from your Barco Projector are out of place, the input signal type (RGBHV/YUV2) might not have been connected properly. Check to make sure that the connections between the projector and the input device are correct.
Basic guidelines and warnings for safe operation of the projector.
Critical instructions to prevent electrical shock and personal injury during use.
Specifies environmental conditions and safety area for projector installation.
Outlines different mounting and projection setup options.
Details ventilation requirements for proper cooling and operation.
Guide on how to install and remove projection lenses.
Steps for safely connecting the projector to the electrical power supply.
Instructions for positioning and leveling the projector on a surface.
Explains various input ports and communication interfaces available.
Steps for turning the projector on and starting projection.
Safe steps for completely shutting down and unplugging the projector.
Guide on accessing the professional-use advanced settings menu.
How to choose the active video or data input signal.
Adjusting the difference between light and dark areas of the image.
Adjusting the black level and overall image lightness.
Selecting lamp operating modes (Eco, Normal, Power) for brightness and lifespan.
Configuring projection mode (front/rear, ceiling/desktop).
Correcting trapezoidal distortion caused by projection angle.
Restores all projector settings to their original factory defaults.
Step-by-step guide for safely replacing the projector lamp.
Instructions for replacing air intake filters to maintain cooling.
Common problems and their solutions for projector issues.
To Next Page
General
