45
5.3.1. SD Card
This subsection shows the capacity of the memory card and the amount of memory available.
Moreover, and indication of the remaining lifetime is displayed.
You can format the memory SD card with the relative button: this erases ALL the data memorized
on the card. A dialog box pops up and ask for confirmation.
Wait until the formatting is done – takes approx. 10 seconds.
NOTE: a single file cannot be deleted.
Figure 5.3.1. Subsection dedicated to SD-card.
5.3.2. Time
In this tab you configure the timing services of the SB. In the Timezone section you can choose
whether you prefer the SB to work with UTC time, or local time. This only makes sense if you have
activated time synchronization.
In the Time synchronization section you activate the synchronization with an external source.
Disabled means that you don't need continuous synchronization. The internal clock keeps
the time even when the unit is powered off. However, electronics component involved in
timekeeping always have a drift, depending on unpredictable factors like temperature. As a
consequence, the SB will slowly drift away from the right time.
You can set the time of the MR3000 equal to the time of your PC, by means the functionality
“Set time with your computer time”.
To Next Page
Loading...
Need help?
General
