58
With modify settings you can modify the unit of measure of the sensor. It is possible to select
metric or imperials units, in particular mg (default value) or m/s2 or in/s2.
NOTE: if you do not want to change the settings please click on CANCEL, because otherwise the
MR will reboot.
5.3.13. Monitoring
The section Monitoring has been added in firmware version 2.0.7. It includes the possibility to
choose the warning level of the power supply voltage of the device.
In particular, two threshold levels must be indicated by the user:
• warning threshold, meaning that a warning is created when the voltage measured
decreases below this level.
• release threshold, meaning that the warning condition is released when this level is
exceeded.
Figure 5.3.14. Subsection dedicated to the system monitoring.
To Next Page
Loading...
Need help?
General
