Basler DECS-150 - Page 142

19-8 9492600990
BESTlogic™Plus DECS-150
Name
Description
Symbol
Setpoint at Upper
Limit
True when the active modes setpoint is at
the upper limit.
Soft Start Active
True during softstart.
Start Status
True when the unit is in Start mode.
Tracking Comms
Loss
True when the DECS-150 is configured as
the secondary DECS-150 and has lost
tracking communications from the primary
DECS-150.
UEL
True when the Under Excitation Limiter is
active.
Underfrequency
V/Hz
True when the Under Frequency or the
Volts/Hz Limiter is active.
Unknown Network
Load Share
Protocol Version
True when there is another unit on the
network whose load share protocol version is
not the same as this units load share
protocol version.
Var Controller
Active
True when the unit is in var mode.
Voltage Matching
Active
True when voltage matching is active.
Output Objects
Physical Outputs
OUT1 and OUT2
Physical outputs 1 and 2.
Physical Outputs
Breaker Shunt
Trip Output
Breaker Shunt Trip physical output.
This output is an electronic switch capable of
100 mAdc that can be used to control an
external circuit breaker.
Off-Page Objects
Off-Page Output
Used in conjunction with the Off-Page Input
to transform an output on one logic page into
an input on another logic page. Outputs can
be renamed by right-clicking and selecting
Rename Output. Right clicking will also show
pages that the corresponding inputs can be
found on. Selecting the page will take you to
that page.
Off-Page Input
Used in conjunction with the Off-Page Output
to transform an output on one logic page into
an input on another logic page. Inputs can be
renamed by right-clicking and selecting
Rename Input. Right clicking will also show
pages that the corresponding outputs can be
found on. Selecting the page will take you to
that page.
Alarms
Global Alarm
True when one or more alarms are set.