Parameter
34 V-Controller (BUS 6 VC)
5.03047.01 Baumüller Nürnberg Electronic GmbH & Co. KG
P090 PU mode
The parameters P114, P113 and P119 can only be changed, if PU Mode 0001
hex
is set and
the password is correct.
P117 PU type
The parameter displays the type of the power unit. The value 0 characterizes an unknown
power unit.
Bit no. Meaning
0 0 : Read the power unit´s specifier, data is set according to the specifier
1 : Specifier is not read, PU data is read from EPROM
1
Short circuit monitoring temperature sensor
0 :If the temperature falls below the threshold value of -40°C the error bit in the
PU status is set and the controller is disabled.
1 :If the temperature falls below the threshold value of -40°C only the warning bit No. 9 in
the PU status is set. The controller is not disabled.
2 ... 15 reserved
Version Power unit PWM frequency
P103 = 8 kHz
nominal/peak cur-
rent effective
PWM frequency
P103 = 4 kHz
nominal/peak cur-
rent effective
Overload time in s
6210 BUS621 5 A / 7,5 A 6,3 A / 7,5 A 1
6211 BUS621 10 A / 15 A 12,5 A / 15 A 1
6212 BUS621 3 A / 3,7 A 3,1 A / 3,7 A 1
622 BUS622 15 A / 22 A 18,3 A / 22 A 1
623 BUS623 20 A / 30 A 25 A / 30 A 1
6240 BUS624 38 A / 57 A 47,5 A / 57 A 1
6241 BUS624 45 A / 67,5 A 56,3 A / 67,5 A 1
600 BUM60 12 A / 24 A 12 A / 24 A 1
601 BUM60 6 A / 12 A 6 A / 12 A 1
602 BUM60 3 A / 6 A 3 A / 6 A 1
612 BUM61 24 A / 45 A 30 A / 45 A 1
613 BUM 61 32 A / 60 A 40 A / 60 A 1
62 BUM62 57,7 A / 75 A 75 A / 97,5 A 120
6203 BUM62T 75 A / 97 A 100 A / 130 A 120
6201 BKH62 75 A / 97,5 A 90 A / 97,5 A 1
63 BUC63 115 A / 150 A 150 A / 195 A 120
6301 BKH63 150 A / 195 A 180 A / 195 A 1
64 BUC64 231 A / 300 A 300 A / 390 A 120
To Next Page
Loading...