Technical Data
V-Controller (BUS 6 VC) 9
Baumüller Nürnberg Electronic GmbH & Co. KG 5.03047.01
2 TECHNICAL DATA
2.1 General
This variant of the V-Controller is designed for the fully digital control of the Baumüller feed/feed back
units BUC63 and BUC64. With this V-controller the intermediate circuit direct voltage Uzk is held on a
constant value.
All other known V-Controller variants are designed for speed control of AC motors.
Closed-Loop Control Functions
! U
zk
control at 62,5 µs
! Current control at 62,5 µs
– The controller is operated by digital inputs. Via the serial interface RS232 serial port and a PC
the parameterization, commissioning and service as well as archiving control parameter to floppy
disk can be done.
Inputs/outputs
! Digital inputs (24 V):
– Pulse enabling
– 4 programmable function inputs
! Analog inputs:
– 2 analog inputs (0 ... ±10 V), 12 bit resolution
! Serial interfaces:
– RS232 with a transmission rate of 9600 baud, optical separated
! Digital outputs:
–1 relay contact message „ready for use“
–1 programmable function outputs
! Analog outputs
–2 analog outputs (0 ... ±10 V), 12 bit resolution
Operation Software
! Up-/Download with PCBASS (see, Technical Description No. 5.96079)
! PCBASS (see, Technical Description No. 5.94004)
To Next Page
Loading...