Baumuller BUS 6 VC - Page 38

Parameter
36 V-Controller (BUS 6 VC)
5.03047.01 Baumüller Nürnberg Electronic GmbH & Co. KG
P116 PU I limit
This parameter sets the standardization of the current controlling.
Standardization
The limits of this parameter depend on the power unit used.
P118 PU temperature
This parameter displays the power unit´s temperature.
A temperature over 80 °C enables the bit no. 6 in PU state (P115). Exceeds the power unit´s
temperature 85 °C the error 0205
hex
appears.
100 %
↔ I limit
NOTE
The standardization of the current controlling must not be changed if pulses are enabled.