10. Operating Instructions – Make Adjustments
10-8 HomeChoice APD Systems Patient At-Home Guide October 2, 2009 07-19-61-244
10.2.6 I-Drain Time
Review or adjust the I-DRAIN TIME setting if you change your Last Fill Volume or
if you perform a CAPD exchange during the day.
h
NOTE:
Initial Drain Time (I-DRAIN TIME) appears in Low Fill Mode only.
Steps to set the I-Drain Time Display screen
1. Press
ENTER to access the MAKE ADJUSTMENTS
menu.
2. Press
V until I-DRAIN TIME appears.
3. Press
ENTER.
The digits blink.
(The digits blink)
4. Press U or V to change the minutes.
30 minutes is the maximum time you can set.
5. Press
ENTER to save the Initial Drain Time.
The blinking stops.
(Blinking stops)
6. Press V to display the next option.
– OR –
7. If you do not want to make any other adjustments,
press
STOP to exit Make Adjustments.
To Next Page
Loading...
