baxter OV450N User Manual

– 12 –
SETTING VENT OPERATION
1. To program the vent, press the vent button. The vent button
LED will turn on and “OFF” will appear in the top heat
window. This is vent time delay. This is the delay from the
start of the program until the vent will open.
2. Set the time by pressing the "+" or "-" button to increase or
decrease the time.
NOTE: If no buttons are pushed during the vent programming
for 5 seconds, the parameter will not be saved and will back out
of the vent programming.
0FF
0n
111
0
0
20
136
136
138
3. Press the vent button again and “ON” will appear in the top
heat window. This is how long the vent is open for.
4. Adjust the time by pressing the "+" or "-" button to increase
or decrease the time.
5. Press the vent button again to save vent parameters.
NOTE: The vent can be opened and closed during a recipe at
any time by pressing the vent button, if the vent has not been
programmed. The LED on the vent button will illuminate when
the vent is open.

baxter OV450N Specifications

General

Brand	baxter
Model	OV450N
Category	Oven
Language	English