Bay-Tek AXE MASTER - Page 15

15
E
AXE MASTER SETUP
Locate the black plastic wire covers - (Labeled 5)
Part # WACA29090
Slide the black plastic wire cover down into the
slot in the cabinet - this end first.
Ensure the wires are not pinched by the cover, and install 2 of the black 6
X 1 1/4” screws using a # 2 Square Head bit.
Do this for all wire covers.
After all 4 white plastic arrow lights are installed onto the
outside of the cabinet, install the black plastic blocks to hide the
wires.
Carefully climb inside the cabinet
Making sure the wires are connected, feed the excess cable
length back down into the hole.
Now we will start building the roof of the cabinet:
Locate the Single Front Arch - (Labeled E)
Part # AAAR29000
Place this single front arch on the cabinet as shown.
Important: Make sure the T nuts are pointing toward the back of the
game.
A5SCFH040
T nuts point
toward the
back of the
game.
Back of
the game
Secure the single front arch to the cabinet by installing 2 bolts through
the wood into the arch as shown.
Use 2 of the black ¼-20 X 1 1/2” Phillips head bolts and 2 of 1/4” black
washers per side using a # 3 Phillips Head bit.
Make sure both sides of the arch are
secure.
A5WAFL090
A5SCPP025
5