User Manual 13
Safety and compliance
Do not touch the hot parts (heated bed and hot-ends) when the machine is switched on, and wait
15 minutes after it has been switched off before touching them.
Take care about the indications of temperature shown on the screen.
There is a potential risk of burns: the hotend can reach temperatures up to 300 °C, while the
silicone heater mat can reach temperatures of 200 °C. Do not touch either of these parts with your
bare hands.
Do not put any object or part of the body between the mobile parts of the printer, when it is moving
or can start moving.
Specifically the force of the build plate is enough to cause damage.
Always unplug the printer before performing maintenance or modifications.
The printing materials are not innocuous and emit toxic fumes.
Always print in open or well-ventilated spaces and use a protective mask.
Do not breathe closer than 25 cm from the tool head when printing.
To Next Page
Loading...
