User Manual 12
Safety and compliance
12 User Manual
General information
To avoid potential residual risks the user should read and understand the following safety measures (you are
strongly advised to read this before using the machine).
To highlight the areas where extra care should be taken, safety alert stickers have been affixed to the relevant parts
of the machine to warn the user of potential hazards.
Any modifications made to the machine without the manufacturer’s approval will invalidate the product’s
Declaration of Conformity (CE) and warranty.
Consequently, the BARCELONA THREE DIMENSIONAL PRINTERS, S.L. ARE EXEMPT FROM ANY LIABILITY IF THE
USER DOES NOT FOLLOW THE INSTRUCTIONS FOR USE.
Hazards
The following stickers have been affixed to the printer to warn users about the hazardous areas of the machine,
and actions which are not recommended as they will stop the machine from working properly.
Supervise the printer while it is printing to make sure it is working properly.
This device is not a toy. It should not be used by minors under 16 without the supervision of an adult.
The spatula can be a dangerous tool that may cause injuries. Use it only to remove plastic residue after calibration
assistant or a printing job.
Handle the glass printing surface with care. Make sure it is not dropped or hit with anything as this could seriously
damage it.
To Next Page
Loading...
