User Manual 73
Maintenance
This chapter provides an overview of the Epsilon Series User Interface. In order to set up your printer or perform
any operation, please follow the procedures in the corresponding sections: Preparation and Operation.
General maintenance
In general, there are some recommendations when performing general maintenance, but there are some indica-
tions that you must always consider in order to extend product life.
A very important advice is to keep your printer always free of dust and operating in a dry and cool place. We su-
ggest that the printer operates in an environment at temperatures between 15 and 30 ºC and relative humidity be-
low 50%. Regarding the filaments, in general we also advise that the spools that are not currently in use are always
stored in an airtight container, with relative humidity below 50% (although this may vary for certain materials).
Activity Frequency Tools
Clean the printer Daily Cloth
Remove filament leftovers spread
inside the printer
Daily Vacuum cleaner
Compressed air
Remove filament inside the purge
buckets by removing the buckets
Daily -
Clean dust in hotend fans, cooling
fans and build chamber fan
Monthly Compressed air
Change HEPA and active carbon
filter
Every 1500 printing hours
(indicated by the printer)
HEPA/Carbon filter
Update printer OS and firmware If the printer is connected, update
when the update message shows
up.
If it’s not connected, check monthly
on the BCN3D website.
-
To Next Page
Loading...
