User Manual 9
Complies with the essential requirements and any other applicable or required
provisions of the Directives:
2006/42/CEE Machinery Directive
2014/35/UE Low Voltage Directive
2014/30/UE Electromagnetic Compatibility Directive (EMC)
2011/65/UE Restrictions on the use of hazardous substances in electrical and
electronic equipment (RoHS)
2009/125/CE Ecodesign requirements for energy related products
2012/19/UE Waste electrical and electronic equipment
2014/53/UE The harmonisation of Member States’ legislation on the marketing of
radio equipment.
Conformity with the requirements of these directives is justified by the following
harmonised standards:
2006/42/CEE UNE-EN ISO 12100:2012; UNE-EN ISO13732-1 :2008; EN ISO
7010:2012
2014/35/UE UNE-EN 60204-1;UNE-EN 60947-3:2009
2014/30/UE UNE-EN 55022:2011; UNE-EN 55024:2011; UNE-EN 61000-4-3-2:2007
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
The BARCELONA THREE DIMENSIONAL PRINTERS, S.L. hereby declares that the BCN3D Epsilon:
Conformity
BARCELONA THREE DIMENSIONAL PRINTERS, S.L.
Carrer de Miquel Servet, 18, 08850 Gavà, Barcelona
Tel: +34 935 95 43 43
www.bcn3d.com
REI-RAEE: 6989
Changes / modifications not approved by the responsible party could void the user’s authority to operate the
equipment.
To Next Page
Loading...
