Chapter 5: Optimizing cytometer settings 67
2. If you need to select a configuration other than the current
configuration:
a. In the Configurations tab, select a configuration.
b. Click Set Configuration.
c. Click OK.
d. Verify that the configuration you just set matches your flow
cytometer optics.
3. Click OK to close the Cytometer Configuration window.
4. Select File > Exit to close CS&T.
5. Select Edit > User Preferences.
6. Click the General tab and select the Load data after recording
checkbox.
See the BD FACSDiva Software Reference Manual for more
information about cytometer configurations and user preferences.
Next step Running a performance check (page 68)
More information • Setting up an experiment (page 72)
To Next Page
Loading...
