!
CAUTION
1 9/16
1 1/16
1 1/16 1 1/16
4 1/8
1/2
1 1/4
1 1/2
6
5
4
3
6
6.25
3
6.25
6
2.5
PRECAUTIONS
This device IS NOT intended for use as a safety sensor.
Not recommended for dynamic envioronments. (snow, rain, fog, etc.)
Shut off all power before attempting any wiring procedures.
Maintain a clean & safe environment when working in public areas.
Constantly be aware of pedestrian/vehicle trafc around the area.
Always stop pedestrian/vehicle trafc through the doorway when performing tests that may result in unexpected reactions by the door.
ESD electrostatic discharge: Circuit boards are vulnerable to damage by electrostatic discharge. Before handling any board ensure
you dissipate your body’s charge.
Always check placement of all wiring before powering up to insure that moving parts will not catch any wires and cause damage to
equipment.
Ensure compliance with all applicable safety standards upon completion of installation.
DO NOT attempt any internal repair of the sensor. All repairs and/or component replacements must be performed by BEA Inc. Unau-
thorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. May adversely affect the safe and reliable performance of the product and will result in a voided product warranty.
DIMENSIONS
MOUNTING
Wall mounting
Ceiling mounting Bracket dimensions
INSTALLATION TIPS
The sensor must be
rmly fastened to
prevent vibration.
The sensor must not
have any object likely
to move or vibrate in
its sensing eld.
DO NOT cover
the sensor.
Remove the bracket from the sensor.
Drill 2 holes accordingly. If necessary, drill an additional
hole to facilitate wire routing. Fix the bracket rmly.
Position the sensor on the bracket
and fasten the angle adjustment screws.
Avoid exposing the
sensor to sudden
temperature changes
Avoid proximity to neon
lamps, uorescent lights
or moving objects
Page 2 of 9 75.5695.01 EN 20120113
To Next Page
Loading...
