15
Quick Start
Parts and Controls
3.2.1 Display Panel
Figure 3 on next page shows the layout of the display panel.
Display (1)
The display is a 240 x 160 pixel monochrome graphics LCD device with a bright LED
backlight. The display is used to show current control temperature, measurements,
status information, operating parameters, and soft key functions.
udlr Arrow Keys (2)
The Arrow Keys allow you to move the cursor on the display, change the display lay-
out, and adjust the contrast of the display. The contrast can only be adjusted using the
u and d arrow keys while viewing the main display window.
Enter Key (3)
The Enter Key allows you to select menus and accept new values.
SET PT. (4)
The Set Pt. Key allows you to enable the instrument to heat or cool to a desired set-
point. Until this key is enabled, the instrument will not heat or cool. It is in a “sleep”
state for safety of the operator and instrument.
°C/°F Key (5)
The °C/°F Key allows you to change the displayed temperature units from °C to °F
and vice versa.
Menu Key (6)
The Menu Key allows the user to access all parameter and settings menus. From the
main menu, the user can use the soft keys to access submenus and functions.
Exit Key (7)
The Exit Key allows you to exit menus and cancel newly entered values.
Soft Keys (8)
The Soft Keys are the four buttons immediately below the display (labeled F1 to F4).
The functions of the soft keys are indicated on the display above the buttons. The
function of the keys may change depending on the menu or function that is selected.
To Next Page
Loading...
