37
Controller operation
Main Menu
5.2.3.3.4 CAL REF (-R model only)
The CAL REF (REFERENCE INPUT CALIBRATION) menu is used to access the
reference PRT calibration parameters. Use these parameters to adjust the measurement
at 0 and 100Ω.
5.2.3.3.4.1 REF1C0
The REF1C0 parameter is the rst calibration point for the reference resistance.
5.2.3.3.4.2 REF1C100
The REF1C100 parameter is the second calibration point for the reference resistance.
5.2.3.3.4.3 INPUT CAL DATE
The INPUT CAL DATE parameter is the calibration date for the readout. Use the ar-
row keys to enter the calibration date in the format selected in DATE FORMAT.
5.2.3.4 SYSTEM INFO (view only)
The SYSTEM INFO (SYSTEM INFORMATION) menu displays manufacturer infor-
mation regarding the instrument.
5.2.3.4.1 MODEL
The MODEL parameter displays the model number of the instrument.
5.2.3.4.2 SERIAL
The SERIAL (SERIAL NUMBER) parameter displays the serial number of the
instrument.
5.2.3.4.3 FW VER
The FW VER (FIRMWARE VERSION0 parameter displays the rmware version
used in the instrument.
5.2.3.4.4 CAL DATE
The CAL DATE (CALIBRATION DATE) parameter displays the calibration date of
the heat source.
5.2.3.4.5 INPUT CAL DATE (-R model only)
The INPUT CAL DATE (-R CALIBRATION DATE) parameter displays the calibra-
tion date for the readout or the -R module.
To Next Page
Loading...
