Becker C18 PLUS - Lower Point to Upper Stop; Deleting Limit Positions (Centronic); Deleting Individual Limit Positions; Deleting Both Limit Positions

Lower point to upper stop
Close to the desired lower limit position.
Press the programming button and, within 3 seconds, also press the button and
hold the two buttons down.
▻ The tubular drive acknowledges.
Then open as far as the permanent stop.
▻ The tubular drive switches off automatically.
► The limit positions are now set.
Deleting the limit positions
Attention
When both or individual limit positions are deleted, all the other set functions (intermediate
position I, intermediate position II, obstacle detection, run times) are deleted as well.
Once set, the limit positions can only be deleted with the master transmitter. Deleted limit
positions are displayed on the limit position status indicator.
Deleting individual limit positions
Open/close to the limit position to be deleted.
Press the programming button and, within the next 3 seconds, press the STOP button
at the same time and hold the two buttons down for 10 seconds.
▻ The tubular drive acknowledges.
► The limit position is now deleted.
Deleting both limit positions
Any additional functions that may have been set are deleted at the same time, or are reset
to the factory default settings.
Open/close the shading solution to a point between the limit positions.
Press the programming button and, within the next 3 seconds, press the STOP button
at the same time and hold the two buttons down for 10 seconds.
▻ The tubular drive acknowledges.
► The limit positions are now deleted.
Intermediate positions I + II
The intermediate positions I + II are freely selectable positions for the shading solution
between the two limit positions. Each travel button can be assigned one intermediate posi-
tion. Both limit positions must be set before an intermediate position is set.
Setting/modifying the desired intermediate position
Open/close the shading solution to the desired intermediate position.
or
Press the STOP button and, within 3 seconds, also press the desired travel button
and hold the two buttons down.
▻ The tubular drive confirms.
► The intermediate position is now saved.
23-en