Becker C18 PLUS - Deleting Run Times (CentronicPLUS); Deleting Run Times (Centronic); Activating;Deactivating Run Times (CentronicPLUS)

Deleting the run times with a CentronicPLUS transmitter
When deleting, both run times are always deleted.
10s
Press the STOP button for 10 seconds.
▻ The receiver confirms.
▻ The transmitter confirms with red pulsing of the LED ring.
► The run times are now deleted.
Deleting the run times with a Centronic transmitter
When deleting, both run times are always deleted.
10s
Press the STOP button for 10 seconds.
▻ The receiver confirms.
► The run times are now deleted.
Activating/ deactivating the run times with a CentronicPLUS transmitter
The run times are activated and deactivated via the manual/ automatic changeover at the
transmitter.
3s
Press the STOP button for 3seconds to display the current status.
Automatic mode: The LED ring lights up green.
Manual mode: The LED ring lights up red.
Different modes: The LED ring lights up yellow.
5s
You can toggle between manual and automatic mode by pressing the STOP button
for 5seconds.
Activating/ deactivating the run times with a Centronic transmitter
This function is only available with MemoControl transmitters from the Becker Centronic
range of control units.
The Memo function is activated and deactivated via the slide switch. The last changeover to be performed is valid.
In the " " operating mode, this movement is repeated every 24 hours.
In the slide switch position " ", no automatic drive commands will be executed.
28-en