102 DeepMind 12 User Manual
RoomRev (ROOM REVERB)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1 PRE PreDelay ms 0.0 200.0 ms Controls the amount of time before the reverb is heard following the source signal.
2* DCY Decay s 0.3 s 28.9 s Controls the amount of time it takes for the reverb to dissipate.
3 SIZ Size m 4.0 m 76.0 m Controls the perceived size of the space being created by the reverb.
4* DMP Damping Hz 1000 Hz 20000 Hz Adjusts the decay of the high frequencies within the reverb tail.
5 DIF Diusion % 0.0% 100% Controls the initial reection density.
6* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals.
7* LC LoCut Hz 10.0 Hz 500.0 Hz Allows the low frequencies aected by the reverb to be reduced.
8* HC Hi Cut Hz 200.0 Hz 20000.0 Hz Allows the high frequencies aected by the reverb to be reduced.
9* LFX BassMult -- 0.2 4.0 Controls the low frequency build-up.
10 SPR Spread -- 0.0 50.0 Emphasizes the stereo eect of the reverb.
11* SHP Shape -- 0.0 250.0 Adjusts the contour of the reverberation envelope.
12 SPI Spin % 0.0% 100% Controls randomization / modulation eects within the reverb.
* These parameters are available as modulation destinations in the Modulation Matrix
VintageRev (VINTAGE ROOM REVERB)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1 PRE PreDelay ms 0.0 200.0 ms Controls the amount of time before the reverb is heard following the source signal.
2 SIZ Size % 1.0% 100% Controls the perceived size of the space being created by the reverb. Aects DECAY range.
3* DCY Decay s 0.1 s 20.7 s Controls the amount of time it takes for the reverb to dissipate. Range dependant on SIZE.
4* LFX Lo Mult -- 0.1 10.0 Controls the low frequency build-up.
5* HFX Hi Mult -- 0.1 10.0 Controls the high frequency build-up.
6* DEN Density % 0.0% 100% Manipulates the reection density in the simulated room.
7* LC LoCut Hz 10.0 Hz 500.0 Hz Allows the low frequencies aected by the reverb to be reduced.
8* HC Hi Cut Hz 200.0 Hz 20000.0 Hz Allows the high frequencies aected by the reverb to be reduced.
9* ERL ER Level % 0.0% 100% Set the early reection times.
10 ERD ER Delay ms 0.0 200.0 ms Sets the loudness of the early reection level.
11* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals.
12* FRZ Freeze -- OFF ON Applies freeze mode and blends signals into a continuous response.
* These parameters are available as modulation destinations in the Modulation Matrix