109 DeepMind 12 User Manual
MulBndDist (MULTIBAND DISTORTION)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1* IPG InputGain dB -24.0 dB 24.0 dB Controls the amount of input gain applied to the signal.
2 DST Dist Types — — — Distortion Type: VAL(Valve), SAT(Saturation), TUB (Tube), & Post Filter variants (PFV/PFS/PFT).
3* LBL Low Level dB -12.0 dB 12.0 dB Controls the level of the frequencies below XoverFreq 1.
4* LDR Low Drive % 0.0% 100% Controls the percentage of distortion introduced below XoverFreq 1.
5* XV1 Xover Freq 1 Hz 30.0 Hz 9000.0 Hz Sets the lower cross over frequency.
6* MBL Mid Level dB -12.0 dB 12.0 dB Controls the level of the frequencies between Xover1 Freq and Xover2 Freq.
7* MDR Mid Drive % 0.0% 100% Controls the percentage of distortion introduced between Xover1 Freq and Xover2 Freq.
8* XV2 Xover Freq 2 Hz 30.0 Hz 9000.0 Hz Sets the upper cross over frequency.
9* HBL High Level dB -12.0 dB 12.0 dB Controls the level of the frequencies below XoverFreq 2.
10* HDR High Drive % 0.0% 100% Controls the percentage of distortion introduced above XoverFreq 2.
11 CAB Cabinet — — — Cabinet Type: OFF, VTw, VBs, A10, Mid, BFC, B60, V30, S78, Oax, A12, Rck. (See Table Above).
12* OPG OutputGain dB -12.0 dB 12.0 dB Controls the amount of output gain applied to the signal.
* These parameters are available as modulation destinations in the Modulation Matrix
RackAmp (RACK AMPLIFIER)
No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION
1* PRE PreAmp — 0.0 10.0 Adjusts the amount of input gain prior to the band-specic distortion adjustment.
2* BUZ Buzz — 0.0 10.0 Adjusts the amount of low-end breakup.
3* PNC Punch — 0.0 10.0 Adjusts the amount of midrange distortion.
4* CRN Crunch — 0.0 10.0 Tailors the high-frequency content and distortion for smooth or cutting notes.
5* DRV Drive — 0.0 10.0 Emulates the amount of power amp distortion from a tube amp.
6* LVL Level — 0.0 10.0 Controls the overall output level.
7* LOW Low — 0.0 10.0 EQ adjustment of the low frequencies, independent of distortion content.
8* HI High — 0.0 10.0 EQ adjustment of the high frequencies, independent of distortion content.
9 CAB Cabinet — OFF ON Turns the cabinet simulation on or o.
* These parameters are available as modulation destinations in the Modulation Matrix
To Next Page
Loading...
Need help?
General
