3.2.8 Undo-Redo Function
With the Undo-Redo Function you compare easily acoustical two different settings of a single
DCX2496 function, e.g. the check of the gain level change for a mid-range speaker for a 3-
way loudspeaker box.
Steps:
1. Adjust a DCX2496 parameter, like gain level “Out 2” to -5dB.
2. Press the button to the store the last change.
3. Adjust the same parameter to another value, like gain level “Out 2” to -2dB.
4. Press the button to recall the stored value from step 2, for the example gain level
out 2 is set to -5dB.
5. Press the button again to recall the previous value from step 3, for the example
gain level out 2 is set to -2dB.
6. Each repeated press switches between the two values.
Note: The Undo-Redo function is also applicable for cut-off frequencies or delays and other
functions.
Note: The output and input stereo link configuration must be switch off.
To Next Page
Loading...
