GB Sound module USM-RC-3
11.10.2021 BEIER-Electronic 67
The "Startup function" is always started when the module is switched on (supply
voltage applied).
Volume
You can also configure the basic volume (10-100%) of the module here. This
function is helpful if you don’t use a volume control potentiometer. The volume can
also be adjusted e.g. with a proportional channel configured with the functions
“Volume +“ and “Volume -“.
Another option to change the volume with the transmitter is the "Direct volume
control". One of the four proportional channels can be used for a stepless volume
setting. You need a free slide or rotary control at your transmitter for that. However,
this proportional channel can only be used for adjusting the volume and not for any
other functions anymore!
To get a more realistic driving sound, a dynamic engine sound volume adjustment
can be activated. The volume of the engine sound gets louder depending on the
acceleration and speed. So whenever the engine needs more power. In standing
position the volume is automatically by this percentage less! Therefore, we
recommend selecting a low value at this setting.
Battery voltage monitoring
The type of battery used can be selected here. The thresholds for "charge battery"
and "undervoltage" are adjusted for each battery type. If your battery type is not
included, both values can also be set manually.
If the battery voltage is permanently below the respective threshold, the warning
message is repeated over and over again within an adjustable time (10 - 250 s).
The corresponding warning sounds must be stored in the Sound-Teacher under
"Additional sounds" (at the bottom). You will find sound templates on the DVD.
In addition, you can choose whether the sound output and / or the switching outputs
should also be switched off in the event of undervoltage. The warning sound "Sound
at undervoltage" is still played.
Multi function
Up to 3 functions can be assigned to each of the 4 multi functions. Using the multi
function 3 functions can be activated at the same time, using only one position at the
transmitter.
For instance: You would like to activate a searchlight and at the same time a servo
sequence should be activated as well. This servo sequence controls a servo, which
moves the searchlight. Without the multi function you would need 2 functions,
triggered at the transmitter:
a. Output x on
b. Servo sequence x on
Using the multi function you can activate at the same time both, the output and the
servo sequence by triggering only one function at the transmitter.
To Next Page