GB Sound module USM-RC-3
11.10.2021 BEIER-Electronic 71
Stationary/motion/gear hysteresis:
When the vehicle is moving very slowly and the sound constantly alternates between
idle and running sound, then this value should be raised slightly.
Also if the engine sound alternates steadily between two speed steps/gears while
driving, this value should be raised slightly, as well. Values between 1 and 10 are
possible.
Driving sound diagram:
The diagram shows graphically which driving sound/gear is played at the
corresponding speed. In addition it is possible to set the driving sound directly in the
diagram (see page 101).
To Next Page
Loading...