Beko DRYPOINT M intelligence - Transport and Storage

Installation and operation instructions US-EN
6 DRYPOINT
®
M intelligence
1.4. Transport and storage
Despite our best eorts regarding packaging, etc., the device might be damaged during transport. Upon receipt, please
remove all packaging material and inspect the product for visible damage. If you detect such damage, immediately notify
the carrier company and BEKO TECHNOLOGIES GMBH or one of its agents.
CAUTION Damage caused during transport or storage
Incorrect transport or storage, or the use of unsuitable lifting equipment might cause damage to
the device.
• The device must only be transported and stored by authorized and suitably trained technical
personnel.
• If you detect any damage, do not start the device.
• Adhere to the permissible storage and transport temperatures (see technical data).
• Protect the device against direct sunlight and heat radiation.
The device must be stored in the original
packaging, sealed the packaging and stored
in a dry and frost-free room. Ensure that the
storage temperature does not exceed the limits
specied on the name plate.
Even when packaged, take suitable measures to
protect the device against the elements.
While in storage, secure the device so that it
cannot topple over or fall, and protect it against
vibration.
NOTICE Recycling of packaging material
• The packaging material is recyclable. Dispose of the packaging material according to the
applicable statutory regulations of the destination country.