RCM410R-x_D00403_01_M_XXEN/09.2020 19
LINETRAXX® RCM410R-1/-2
4.1.6.3 "NFC" function
The "NFC" function can be enabled or disabled. This function is for service purposes only. The NFC
function is enabled by pressing the T/R button for a period of 6 s to 10 s. The status LED indicates
when the NFC function is enabled. The LED lights green with blue flashes. The enabled NFC func-
tion can be disabled by pressing the T/R button again for a period of 6 s to 10 s. Otherwise, it is
automatically disabled after 5 min.
4.1.6.4 "Addr." function
The "Addr." function puts the device into the address setting mode for the RS-485 interface. The
LED measured value display and the status LED indicate the devices address.
How to enter an address:
1. Press T/R button until the status LED flashes green.
– After releasing the T/R button, the status LED lights RED.
2. Set HUNDREDS DIGIT. Press T/R button briefly until the desired value appears. Press and
hold T/R button once (> 2 s) to confirm .
– After releasing the T/R button, the status LED lights GREEN.
3. Set TENS DIGIT. Press T/R button briefly until the desired value appears. Press and hold
T/R button once (> 2 s) to confirm.
– After releasing the T/R button, the status LED lights BLUE.
4. Set UNITS DIGIT. Press T/R button briefly until the desired value appears. Press and hold
T/R button once (> 2 s) to confirm.
5. To exit the address setting mode, press and hold T/R button once (2 s).
– After releasing the T/R button, the status LED lights GREEN.
The address values are displayed via BCD code.
Addresses can only be entered within the valid address range. The valid address range is protect-
ed on the software side by an input mask.
1 5 3
Current address: 153
Factor
4
1
2
8
x100
x10 x1
Sum
To Next Page
Loading...
