RCM410R-x_D00403_01_M_XXEN/09.2020 7
LINETRAXX® RCM410R-1/-2
1.8 Safety
If the device is used outside the Federal Republic of Germany, the applicable local standards and
regulations must be complied with. In Europe, the European standard EN 50110 applies.
I
Danger! Risk of electrocution due to electric shock! Touching live parts of the system
carries the risk of:
- A fatal electric shock
- Damage to the electrical installation
- Destruction of the device
Before installing and connecting the device, make sure that the installation has been
de-energised. The rules for working on electrical systems must be observed.
1.9 Intended use
The RCM410R devices in conjunction with the specified measuring current transformers (CT) are
intended for AC and pulsed DC sensitive residual current measurement according to IEC 62020.
The area of application is the monitoring of residual currents I
Δ
for preventive maintenance in TN,
TT and IT systems with I
Δ
≤ 50 A rms, whereby I
Δ
is intended to be measured within the range f=
42…70 Hz.
The devices are intended for operation in control cabinets or similarly protected environments.
For intended operation, observe the specifications in the manual.
Any other use than that described in this manual is regarded as improper.
To Next Page
Loading...
Need help?
General
