Bender VME420 - Setting the Time Delays

Operation and setting
37
VME420_D00026_03_M_XXDE/04.2019
5.5.5 Setting the time delays
Setting range 0…300 s
 Response delay for K1 t
on1
 Response delay for K2 t
on2
 Start-up delay during device start t
 Common delay on release for K1 and K2: t
off
(t
off
is only relevant if fault memory M is deactivated)
The operating steps for the setting of the response delay t
on1
and the start-up
delay t are illustrated by way of example.
Setting the response delay t
on1
Setting the start-up delay t
2x
>1,5 s
2x
>1,5 s
2x