13
OPERATING SETTINGS – LEVEL 1
COLD INFLATION PRESSURE
Factory default 30 PSI = 2.08 Bar
This function changes the cold inflation pressure
for each axle.
Programming Steps
1.
Enter Level 1 Programming Mode
(see page 12)
2.
Press the TIRE button to scroll to the
desired axle. The tires of the selected axle
are filled in.
3.
Press the MODE button to view the
current value.
4.
Press the TIRE button to increase the value.
5.
Press the MODE button to decrease the
value.
6.
Press the SET button to save when the
desired value is reached.
Repeat programming steps 2-6 until Cold Inflation
Pressure levels are set for all axles as desired.
7.
Press the SET button to exit.
8.
Press the SET button again to revert to
normal view.
35 PSI = 2.40 Bar
To Next Page
Loading...
Need help?
General
