21
ADVANCED PROGRAMMING – LEVEL 2
SLOPE
Factory default 44
Do not change the factory setting for this mode without first contacting your
SmarTire retailer.
The Slope is a value corresponding to the rate of pressure change due to
temperature for a particular tire. This value affects the calculation to determine
pressure deviation value.
Programming Steps
1.
Enter Level 2 Programming Mode
(see page 12)
2.
Press the TIRE button to scroll to the
desired axle, the tires of the selected axle
are filled in.
3.
Press the MODE button to display the
current value of slope for the selected axle.
4.
Press the TIRE button to increase the value.
5.
Press the MODE button to decrease the
value. The minimum value is 10 and the
maximum is 160.
6.
Press the SET button to save the value.
Repeat steps 2-6 until the slope level is set for all
axles as desired.
To Next Page
Loading...
Need help?
General
