23
• By inflating or deflating the tire by more than
3 PSI (0.2 Bar).
This method must be carried out while the trans-
mitters are in “gauge fill” mode. This mode is
entered for 15 minutes after the vehicle has been
driven above 6 mph (10 kph). Each transmitter
“learn operation” must be carried out at least 90
seconds apart. If it is not possible to complete the
learn operation for all transmitters within 15
minutes, the vehicle must again be driven above
6 mph (10 kph) and then the process can be
continued.
Note: To prevent the last identification being
erased, scroll to next tire position before driving.
A beep and rapid flashing of the alarm light
indicate a transmission was received. The new ID
is stored.
6.
To remove the transmitter from the
selected tire location, press the MODE
button.
7.
Press TIRE button to scroll to another
position and repeat step 4 or 5 as required.
8.
Press the SET button to save and exit.
If no error is found, the system will reset and go
to normal mode.
learn – cont’d
To Next Page
Loading...
Need help?
General
